Installing The Switch In An Equipment Rack; Required Items; Switch Orientations In The Equipment Rack; Figure 34: Bracket Holes On The Switch - Allied Telesis x530DP Series Installation Manual

Chapter 6: Installing the Switch in an Equipment Rack

Installing the Switch in an Equipment Rack

Required Items

Switch
Orientations in
the Equipment
Rack
104
This section contains the procedure for installing the switch in a standard
19-inch equipment rack using the brackets supplied with the unit.
Note
For sliding rack mount installation instructions see Appendix B,
"Installing the Switch in the RKMT-SL01 Sliding Rack" on page 177.
The following items are required to install the switch in an equipment rack:
Two equipment rack brackets (included with the switch)

Eight M4x6mm bracket screws (included with the switch)

Cross-head screwdriver (not provided)

Four standard equipment rack screws (not provided)

The switch has two sets of four screw holes on the left and right sides, for
attaching the brackets. Refer to Figure 34.
Figure 34. Bracket Holes on the Switch
Bracket Holes