Table of Contents
Advertisement
Chapter 9: Building the Stack Trunk with 5Gbps Multi-Speed Ports
Table 17. Configuring the Master Switch for 5Gbps Stacking Ports - Part II (Continued)
Step
4
Remove the stacking function from the ports to convert them into regular Ethernet
ports, with the NO STACKPORT command:
awplus(config-if)# no stackport
% Save the config and restart the system for this change to take
effect.
Steps 5 and 6 add the stacking function to the selected 5Gbps stacking ports on the
provisioned member switches.
5
Enter the Interface modes of the 5Gbps ports to be used as the stack trunk on the
provisioned member switches. If you filled out the worksheet on Table 13 on page 73,
refer there for the stacking ports. This example assumes that there are three member
switches that are to use ports 47 and 48 as the stack trunk.
awplus(config)# interface port2.0.47-2.0.48,port3.0.47-
3.0.48,port4.0.47-4.0.48
6
Designate the ports as stacking ports with the STACKPORT command.
awplus(config-if)# stackport
% Save the config and restart the system for this change to take
effect.
Steps 7 to 13 save your changes on the master switch and reboot it.
7
Return to the Global Configuration mode.
awplus(config-if)# exit
8
Return to the Privileged Exec mode.
awplus(config)# exit
9
Enter the WRITE command to save your changes.
awplus# write
Building configuration ...
[OK]
10
Restart the switch with the REBOOT command.
awplus# reboot
reboot system? (y/n):
awplus#
11
Type "Y" for yes.
12
Wait two minutes for the switch to initialize the management software.
138
Description and Command
Advertisement
Table of Contents
