Verifying The Master Switch; Table 18: Verifying The Master Switch - Allied Telesis x530DP Series Installation Manual

Stackable gigabit layer 3+ ethernet switches alliedware plus v5.5.1-2.1
Table of Contents

Advertisement

Table 17. Configuring the Master Switch for 5Gbps Stacking Ports - Part II (Continued)
Step
13
Go to "Verifying the Master Switch" on page 139.
Verifying the
Master Switch
Step
1
Start a new local management session on the master switch.
2
Move to the Privileged Exec mode with the ENABLE command.
awplus> enable
3
Enter the SHOW STACK command. Here is an example of the display:
awplus# show stack
Virtual Chassis Stacking summary information
ID Pending ID
1
-
2
-
3
-
4
-
Operational Status
Stack MAC address
Check the display for the following:
- Switch ID 1 is the master switch.
- The master switch should have the priority 1. If it does not, repeat "Configuring the
Master Switch - Part I" on page 134. Be sure to perform the STACK PRIORITY
command and to save your changes with the WRITE command.
- The other ID entries are for the provisioned member switches. There should be one
entry for each member switch that will be in the stack. Their fields are empty
because the master switch is not yet part of a stack. If the table does not include
these fields, repeat "Configuring the Master Switch - Part II" on page 137. Be sure to
perform the SWITCH PROVISION command and to save your changes with the
WRITE command.
- The Operational Status should be Standalone Unit, indicating that stacking is
enabled, but that the unit is operating as a stack of one switch. If the status is
Stacking Hardware Disabled, the stacking feature is disabled. Repeat "Configuring
the Master Switch - Part I" on page 134. Be sure to perform the STACK ENABLE
command and to save your changes with the WRITE command.
Description and Command
Perform the steps in Table 18 to confirm the configuration of the master
switch.
Table 18. Verifying the Master Switch
Description and Command
MAC address
e0a.ba56.c208
-
-
-
x530DP Series Installation Guide for Virtual Chassis Stacking
Priority
Status
1
Ready
-
-
-
-
-
-
Standalone unit
e01a.ba56.c208
Role
Active Master
Provisioned
Provisioned
Provisioned
139

Advertisement

Table of Contents
loading

This manual is also suitable for:

X530dp-28ghxmX530dp-52ghxm

Table of Contents