Table of Contents
Advertisement
Appendix B: Installing the Switch in the RKMT-SL01 Sliding Rack
Installing the Inner Rails on the Switch
Front of
Switch
196
The sides of the x530DP-28GHXm and x530DP-52GHXm switch have
two sets of bracket screw holes. The smaller M3 holes are for the standard
brackets that come with the switch and the larger M4 screw holes are for
the inner rails of the RKMT-SL01 sliding rack.
The inner rails are attached to the switch with four M4 screws on each
side. Figure 75 identifies the respective screw holes on the inner rails and
sides of the switch.
Figure 75. Inner Rail Screw Holes for the x530DP-28GHXm Switch
Attach the inner rails to the switch using eight M4 screws included with the
sliding rack. Be sure that the UP arrows on the rails are pointing up and
that the extension brackets extend in front of the switch. Refer to
Figure 76.
Figure 76. Attaching the Inner Rails to the x530DP-28GHXm Switch
Go to "Installing the Switch in the Equipment Rack" on page 197.
Advertisement
Table of Contents
