Figure 34: Power Supply Accessory Items; Table 19: Power Supply Accessory Items - Allied Telesis AlliedWare Plus Installation Manual

Chapter 4: Installing the Power Supplies
96
Table 19. Power Supply Accessory Items
Power Supply
AT-PWR150
AT-PWR250
AT-PWR250-80
AT-PWR800
AT-PWR1200
The items are shown in Figure 34 on page 96.
Power Cord
Retaining Clip
Figure 34. Power Supply Accessory Items
Note
The power cord that comes with the AT-PWR1200 Power Supply for
installations in North America has a 20 Amp, 125 V NEMA 5-20P
plug that is only compatible with an NEMA 5-20R receptacle.
5. Slide the new power supply into slot A in the back panel of the switch.
Refer to Figure 35 on page 97.
Please review the following guidelines before installing the module:
The handle on the power supply should be on the left as you install

the module. Refer to Figure 35 on page 97.
When installed, the AT-PWR1200 Power Supply extends 5.6 cm

(2.2 in.) from the back panel of the switch.
One Power Cord
Retaining Clip
Yes
Yes
No
Yes
No
Power Cord
One Power Cord
Yes
Yes
No
Yes
Yes