Command Summary; Stackport - Allied Telesis x530DP Series Installation Manual

Chapter 9: Building the Stack Trunk with 5Gbps Multi-Speed Ports

Command Summary

STACKPORT

130
The following sections briefly describe the commands for configuring
the master and member switches for stacking with the 5Gbps ports.
For further instructions, refer to the Command Reference: x530
Series Switches Running AlliedWare Plus Version 5.5.0 at
www.alliedtelesis.com/library. After reviewing the commands, go to
"Configuring the Master Switch" on page 133 to start the configuration
procedures.
Note
The following instructions in this chapter are for the
x530DP-52GHXm.
This command designates the ports of the stack trunk. After you enter the
command, the designated ports stop functioning as regular Ethernet ports
and function instead as the stack trunk. If you are using the default SFP+
ports as the stack trunk, you do not have to perform this command
because those ports are the default trunk ports. However, if you want to
use the optional 5Gbps ports as trunk ports, you have to designate them
with this command. Refer to Table 12 on page 53 for a list of the default
and optional trunk ports.
The command is performed in the Interface mode of the selected ports. In
this example, the optional stacking ports 47 to 48 on the AT-x530DP-
52GHXm switch is designated as the stack trunk:
awplus(config)# interface port.0.47-.0.48
awplus(config-if)# stackport
To remove the stacking function from ports and return them to regular
Ethernet networking ports, use the NO STACKPORT command. You
might perform this command if you are not using SFP+ ports 51 and 52 as
the stack trunk and want to use them instead as regular Ethernet ports, or
if you inadvertently assign the stacking function to the wrong ports. This
example removes the stacking function from the default stacking ports 51
and 52:
awplus(config)# interface port.0.51-.0.52
awplus(config-if)# no stackport