Figure 18: Power Supply Accessory Items; Table 12: Accessory Items Included With The Power Supplies - Allied Telesis AlliedWare Plus x530DP Series Installation Manual

Chapter 3: Installing the Power Supplies
64
Table 12. Accessory Items Included with the Power Supplies
Power Supply
PWR150 / PWR150R
PWR250
PWR250-80
PWR800
PWR1200
Power Cord
Retaining Clip
Figure 18. Power Supply Accessory Items
Note
The power cord that comes with the PWR1200 Power Supply for
installations in North America has a 20 Amp, 125 V NEMA 5-20P
plug that is only compatible with an NEMA 5-20R receptacle.
5. Slide the new power supply into slot A or B in the back panel of the
switch. Refer to Figure 19 on page 65.
Please review the following guidelines before installing the module:
If you are installing only one power supply, you may install it in

either slot A or B.
The handle on the power supply should be on the left as you install

the module in the switch. Refer to Figure 19 on page 65.
When installed, the PWR1200 Power Supply extends 5.6 cm

(2.2 in.) from the back panel of the chassis.
The power supply is fully installed in the slot when the tabs with the

captive screws are flush with the back panel of the switch. Light
pressure may be required to properly seat the module on the
power connector inside the chassis.
One Power Cord
Retaining Clip
Yes
Yes
No
Yes
No
Power Cord
One Power Cord
Yes
Yes
No
Yes
Yes