Configuring Member Switches - Part Ii - Allied Telesis x530DP Series Installation Manual

Step
9 Return to the Privileged Exec mode.
awplus(config)# exit
10
Enter the WRITE command to save your change. If this is the first management
session, the switch adds the configuration file DEFAULT.CFG to flash memory, for
storing your configuration changes.
awplus# write
Building configuration ...
[OK]
11 Restart the switch with the REBOOT command.
awplus# reboot
reboot system? (y/n):
awplus#
12 Type "Y" for yes.
13 Wait two minutes for the switch to initialize its management software.
14 Check the ID LED on the front panel and do one of the following:
- If the ID LED is displaying the switch's new ID number, go to "Configuring Member
Switches - Part II," next.
- If the ID LED is displaying a different number, repeat this procedure. Be sure to
correctly enter the STACK RENUMBER command and to save your changes with
the WRITE command.
Configuring
Member Switches
- Part II
Step
1 Start a new local management session on the member switch. Refer to "Starting a
Local Management Session" on page 136.
Table 19. Configuring Member Switches - Part I (Continued)
Description and Command
This section contains instructions to the second part to configuring
member switches. The instructions explain how configure the following
parameters:
Set the priority number. For background information, refer to

"Selection of the Master Switch" on page 64.
Designate the optional stacking ports for the stack trunk. Refer to

"Stack Trunks" on page 53.
To configure a member switch, perform the procedure in Table 20.
Table 20. Configuring Member Switches - Part II
Description and Command
x530DP Series Installation Guide for Virtual Chassis Stacking
145