Figure 27: Power Supply Accessory Items; Table 15: Accessory Items Included With The Power Supplies - Allied Telesis AT-x930-28GTX Installation Manual

Chapter 4: Installing the Power Supplies
86
Table 15. Accessory Items Included with the Power Supplies
Power Supply
AT-PWR250
AT-PWR250-80
AT-PWR800
AT-PWR1200
The items are shown in Figure 27 on page 86.
Power Cord
Retaining Clip
Figure 27. Power Supply Accessory Items
Note
The power cord that comes with the AT-PWR1200 Power Supply for
installations in North America has a 20 Amp, 125 V NEMA 5-20P
plug that is only compatible with an NEMA 5-20R receptacle.
5. Slide the new power supply into slot A or B in the back panel of the
switch. Refer to Figure 28 on page 87.
Please review the following guidelines before installing the module:

If you are installing only one power supply, you may install it in
either slot A or B.
 The handle on the power supply should be on the left as you install
the module. Refer to Figure 28 on page 87.

When installed, the AT-PWR1200 Power Supply extends 5.6 cm
(2.2 in.) from the back panel of the chassis.
 The power supply is fully installed in the slot when the tabs with the
captive screws are flush with the back panel of the switch. Light
pressure may be required to properly seat the module on the
power connector inside the chassis.
One Power Cord
Retaining Clip
Yes
No
Yes
No
Power Cord
One Power Cord
Yes
No
Yes
Yes