Ovs-Over Scan; Pcb-Pincushion/Barrel; Pcg-Change Pin - Christie GS Series Technical Reference

OVS–Over Scan
Modifies how the input images edges are framed and removes noise from around the image.
Commands
Command Description
OVS <value> Modifies how the input images edges are
framed and removes noise from around the
image.
Examples
Crop the input image edges:
(OVS 2)
PCB–Pincushion/Barrel
Corrects curved distortion caused by the lens or the projection surface.
This command is not available if a Dual Processor Warp module (DPWM) is not installed.
Commands
Command Description
PCB <value> Corrects curved distortion caused by the lens or the projection
surface. (Write-only)
Examples
Set the pincushion/barrel value to 20:
(PCB 20)
PCG–Change Pin
Changes the personal identification number (PIN) on a projector.
Commands
Command
PCG <00000,NNNNN>
GS Series Serial API Commands Technical Reference
020-000814-01 Rev. 1 (06-2015)
Description
Replaces the existing PIN number, where:
• 00000 = Previous PIN
Serial API commands
Values
0 = Off
1 = Zoom
2 = Crop
Values
0 to 20
10 (Default)
Values
Valid PIN number
12345 (Default)
44