Belt Replacement / Debris Removal - Polaris RZR RS1 2019 Owner's Manual

MAINTENANCE
POLARIS VARIABLE TRANSMISSION (PVT) SYSTEM
Failure to comply with the instructions in this warning can result in severe injury
Do not modify any component of the PVT system. Doing so may reduce its
strength so that a failure may occur at a high speed. The PVT system has been
precision balanced. Any modification will cause the system to be out of
balance, creating vibration and additional loads on components.
The PVT system rotates at high speeds, creating large amounts of force on
clutch components. As the owner, you have the following responsibilities for
• Always follow all recommended maintenance procedures. Always look for
and remove debris inside and around the clutch and vent system when
replacing the belt.
• See your dealer or other qualified service person as recommended in the
owner's manual and on safety labels.
• This PVT system is intended for use on POLARIS products only. Do not
install it in any other product.
• Always make sure the PVT housing is securely in place during operation.

BELT REPLACEMENT / DEBRIS REMOVAL

If a belt fails, always clean any debris from the PVT ducting and from the clutch
and engine compartments when replacing the belt.
Failure to remove ALL debris when replacing the belt could result in vehicle
damage, loss of control and severe injury or death.
110
WARNING
or death.
your own safety and the safety of others:
WARNING