Configuring Ptz Functions; Figure 54 Ptz-Preset; Table 26 Ptz Parameters - Honeywell Performance Series User Manual

Table 26 PTZ Parameters

Parameter
Channel
Type
Protocol
Address
Baud rate
Data Bit
Stop Bit
Parity
3. Click Apply.

Configuring PTZ Functions

Configuring Presets
1. On the expanded PTZ control panel, click

Figure 54 PTZ-Preset

2. Click the direction arrows to the required position.
3. In the Preset box, enter the value to represent the required
4. Click Setting to complete the preset settings.
Configuring Tours
1. On the expanded PTZ control panel, click
52
The Preset interface is displayed.
position.
Performance Series Embedded NVR User Guide
Description
In the Channel list, select the channel that you want to connect
the PTZ camera to.
•
Local: Connect through RS-485 port.
•
Remote: Connect through network by adding IP address of
PTZ camera to the Device.
In the Protocol list, select the protocol for the PTZ camera such as
PELCOD.
In the Address box, enter the address for PTZ camera. The default
is 1.
The entered address must be the same with the address
configured on the PTZ camera; otherwise the system cannot
control PTZ camera.
In the Baud rate list, select the baud rate for the PTZ camera. The
default is 9600.
The default value is 8.
The default value is 1.
The default is value NONE.
.
.