Download Print this page
Honeywell Performance Series Quick Installation Manual

Honeywell Performance Series Quick Installation Manual

4mp hqa fisheye
Hide thumbs Also See for Performance Series:

Advertisement

Quick Links

Performance Series Cameras
HFD40HD4 4MP HQA Fisheye
Quick Installation Guide
Thank you for purchasing a Honeywell Performance
Series HQA HFD40HD4 camera. Follow the instructions
in this guide to install and log in to your camera.
Warnings and Cautions
THIS SYMBOL INDICATES THAT
CAUTION
DANGEROUS VOLTAGE
RISK OF ELECTRIC
CONSTITUTING A RISK OF
SHOCK
ELECTRIC SHOCK IS PRESENT
DO NOT OPEN
WITHIN THE UNIT.
CAUTION: TO REDUCE THE RISK OF ELECTRIC
THIS SYMBOL INDICATES THAT
SHOCK, DO NOT REMOVE THE COVER.
IMPORTANT OPERATING AND
NO USER-SERVICEABLE PARTS INSIDE.
MAINTENANCE INSTRUCTIONS
REFER SERVICING TO QUALIFIED SERVICE
ACCOMPANY THIS UNIT.
PERSONNEL.
WARNING
This device is configured for 12 VDC operation. Do not connect to a higher
voltage. Use only with NRTL-approved Class 2 power supplies.
Important Safeguards
• Read and keep these instructions.
• Confirm the installation surface can support at least three times the weight of the camera.
• Do not apply power to the camera before completing installation.
• Do not aim the camera toward a bright light source for extended periods to prevent damage to the
imager. Avoid operating the unit under or close to unstable light sources (may cause flickering), or
close to fluorescent lamps or objects reflecting light.
• Do not touch the camera lens.
• Do not drop the camera or subject it to physical shock.
• Do not use a strong or abrasive detergent when cleaning the camera.
• Avoid operating or storing the unit in extremely humid, dusty, hot/cold environments, where the
operating temperature is outside the recommended range of -22°F to 140°F (-30°C to 60°C).
Before You Begin
Before you begin, check that you have received all of the parts listed below. If any parts are missing or
damaged, contact your dealer immediately.
• Camera
• Self-tapping screws (×4)
• Mounting template
• Hex key (L-wrench)
CAUTION
Installation and servicing should be performed only by qualified and experienced
technicians to conform to all local codes and to maintain your warranty.
Preparing the Mounting Surface
1. Apply the mounting template to the mounting surface.
2. Using the mounting template as a guide, drill three pilot holes in the mounting surface, then
hammer the supplied anchors into the holes.
3. Drill a cable entry hole in the mounting surface, then pull the required cables through the hole.
Mounting and Aiming the Camera
1. Remove the dome cover from the camera assembly using the supplied hex key.
2. Connect the camera's BNC connector to a coaxial cable.
3. Connect the camera's power connector to a 12 VDC source.
4. Fix the camera assembly to the mounting surface using the supplied screws.
• Plastic anchors (×4)
• Power pigtail
Mounting surface
Mounting template
Anchors
Camera assembly
Self-tapping screws
Dome cover
Mounting screws

Advertisement

loading

Summary of Contents for Honeywell Performance Series

  • Page 1 Installation and servicing should be performed only by qualified and experienced technicians to conform to all local codes and to maintain your warranty. Thank you for purchasing a Honeywell Performance Series HQA HFD40HD4 camera. Follow the instructions in this guide to install and log in to your camera.
  • Page 2 © 2018 Honeywell International Inc. All rights reserved. No part of this publication may be reproduced by any means without written permission from Honeywell. The information in this publication is believed to be accurate in all respects.

This manual is also suitable for:

Hfd40hd4