Figure 175 Region Setting - Honeywell Performance Series User Manual

Parameter
PTZ Linkage
Tour
Picture Storage
Buzzer
Alarm Tone
3. Click Apply to save the settings.
•
•
•
Setting the Motion Detection Region
1. Next to Region, click Setting.
2. Point to the middle top of the interface.

Figure 175 Region Setting

3. Configure the regions settings. You can configure four regions.
•
•
Performance Series Embedded NVR User Guide
Description
Select the check box and click Setting to select the channel and PTZ
action. When an alarm occurs, the NVR device associates the channel to
perform the corresponding PTZ action. For example, activate the PTZ in
channel one to turn to the preset point X.
•
Tripwire alarm supports to activate PTZ preset point only.
•
You need to set the corresponding PTZ actions first, see
Control.
Select the check box and select the channel for tour. When an alarm
occurs, the local interface of the NVR device displays the selected
channel screen.
•
You need to set the time interval and mode for tour first, see Tour.
•
After the tour is over, the preview interface is restored to the screen
split mode before the tour.
Select the Snapshot check box to take a snapshot of the selected
channel.
To use this function, go to Main Menu > CAMERA > Encode > Snapshot,
select Event in Type list.
Select the check box to activate the buzzer when an alarm occurs.
Check the box and then select the corresponding audio file from the
drop-down list. System plays the audio file when the alarm occurs.
Refer to
Click Default to restore the default setting.
Click Copy to, in the Copy to dialog box, select the additional
channel(s) that you want to copy the motion detection settings to,
and then click Apply.
Click Test to test the settings.
The region setting screen is displayed.
The setting interface is displayed.
Select one region, for example, click
Drag on the screen to select the region that you want to detect.
File Management
to add audio file first.
.
PTZ
153