Figure 174 Motion Detection; Table 72 Motion Detection Parameters - Honeywell Performance Series User Manual

Figure 174 Motion Detection

2. Configure the settings for the motion detection parameters.

Table 72 Motion Detection Parameters

Parameter
Channel
Region
Enable
Schedule
Anti-Dither
Alarm-out Port
Post-Alarm
Show Message
Report Alarm
Send Email
Record Channel
Post-Record
152
Description
In the Channel list, select a channel to set the motion detection.
Click Setting to define the motion detection region.
Enable or disable the motion detection function. Check the box
enable the function.
Define a period during which the motion detection is active.
Indicates the time taken from the end of motion detection to the end of
alarm linkage action. The range is 0 to 600 seconds.
The alarm device (such as lights, sirens, etc.) is connected to the alarm
output port. When an alarm occurs, the NVR device transmits the alarm
information to the alarm device.
When the alarm ends, the alarm extended for a period of time. The time
range is from 0 seconds to 300 seconds.
Check box to enable a pop-up message in your local host PC.
Select the check box. When an alarm occurs, the NVR device uploads an
alarm signal to the network (including the alarm center).
•
This function is for some series products only.
•
You need to set the alarm center first. For details, see
Select the check box. When an alarm occurs, the NVR device sends an
email to the set mailbox to notify the user.
You need to set the email first. For details, see Email.
Select the check box and select the needed recording channel (support
multiple choices). When an alarm occurs, the NVR device activates the
channel for recording.
You need to enable intelligent recording and auto recording first. For
details, see Schedule.
At the end of the alarm, the recording extends for a period of time. The
time range is from 10 seconds to 300 seconds.
Performance Series Embedded NVR User Guide
to
Alarm Center.