Figure 172 Alarm-in Port
2. Set Alarm-in Port channel number and then select the Enable
3. Configure parameters.
Table 71 Alarm-in Port Parameters
Parameter
Alarm-in Port
Enable
Alarm Name
Device Type
Schedule
Alarm-out Port
Post-Alarm
Show Message
Report Alarm
Send Email
Performance Series Embedded NVR User Guide
check box to enable the function.
Description
Select a channel to set alarm.
Check the box
Enter an alarm name.
NO (normal open) or NC (normal close).
Define a period during which the alarm is active. For details, see
Detection.
The alarm device (such as lights, sirens, etc.) is connected to the alarm
output port. When an alarm occurs, the NVR device transmits the alarm
information to the alarm device.
When the alarm ends, the alarm extended for a period of time. The time
range is from 0 seconds to 300 seconds.
Check box to enable a pop-up message in your local host PC.
Select the check box. When an alarm occurs, the NVR device uploads an
alarm signal to the network (including the alarm center).
•
This function is for some series products only.
•
You need to set the alarm center first. For details, see
Select the check box. When an alarm occurs, the NVR device sends an
email to the set mailbox to notify the user.
You need to set the email first. For details, see Email.
to enable the function.
Motion
Alarm Center.
149