Reset Button; Figure 26 Password Reset 2; Figure 27 Reset Button - Honeywell Performance Series User Manual

Figure 26 Password Reset 2

4. Click OK. The password resetting is complete.
5. (Optional) Click OK to synchronize password to remote devices.

Reset Button

You can use the reset button on the mainboard to reset the Device to the
factory default settings.
Note: Reset button is for some series product only.
1. Disconnect the Device from power source, and then remove the
2. Find the reset button on the mainboard, and then connect the
3. Press and hold the reset button for 5 seconds to 10 seconds.

Figure 27 Reset Button

4. Restart the Device.
5. After the Device is restarted, the settings have been restored to the
26
cover panel.
Device to the power source again.
factory default. You can start resetting the password.
Performance Series Embedded NVR User Guide