Setting Switch; Figure 72 Switch Interface; Table 40 Poe Port Description - Honeywell Performance Series User Manual

3. Click Apply to complete the settings.

Setting Switch

After setting Switch, when an IPC is connected to the PoE port, the
system automatically assigns the IP address to the IPC according to the
set IP segment, and the NVR will automatically connect to the IPC.
Note:
•
•
•
•
1. Go to Main Menu > Network > Switch.

Figure 72 Switch Interface

2. Set the values of IP Address, Subnet Mask and Default Gateway.
3. Click Apply.

Table 40 PoE Port Description

PoE Status
Connect to PoE port
Disconnect PoE port
70
Only models with PoE ports support this function.
Do not connect the PoE port with a switch, otherwise it will cause
connection failure.
This function is enabled by default, and the IP segment start from
10.1.1.1, we recommend that you use the default setting.
When connecting to a third-party IPC, make sure that the IPC
supports Onvif protocol and DHCP is enabled.
Do not set the value of IP Address to the same network segment
with the NVR, we recommend that you use the default setting.
Description
When an IPC is connected to the PoE port, the system automatically
assigns the IP address to the IPC according to the set IP segment.
The NVR will try the method of arp ping to assign the IP address. If
DHCP is enabled on the NVR, the NVR will use DHCP to assign the IP
address.
•
•
When an IPC is disconnected form PoE port, you will find the
information of Failed to find network host on the Live View interface.
Performance Series Embedded NVR User Guide
When IP address is successfully set, the system will broadcast
though Switch. If there is a response from the IPC, it means the
connection is successful, and the NVR will log in with the IPC.
You can find the corresponding channel being occupied and
there is an PoE icon at the upper-left corner.
You can also view PoE status such as channel number and PoE
port number in Main Menu > CAMERA > Camera List > Added
Device