Attack Defense; Figure 125 Firewall; Table 55 Firewall Parameters - Honeywell Performance Series User Manual

4. Click Certificate Management to create or import a HTTPS
5. Select a HTTPS certificate.
6. Click Apply to complete the settings.

Attack Defense

Firewall
1. Go to Main Menu > Security Center > Attack Defense > Firewall.

Figure 125 Firewall

2. Select Enable to enable firewall.
3. Configure the parameters.

Table 55 Firewall Parameters

Parameter
Mode
Add
Type
IP Address
Start Port
End Port
Performance Series Embedded NVR User Guide
certificate from USB drive. For details about importing or creating a
CA certificate, see CA
The Firewall interface is displayed.
Description
Mode can be configured when Type is Network Access.
If Trusted Sites is enabled, you can visit device port successfully with
•
IP/MAC hosts in Trusted Sites.
If Blocked Sites is enabled, you cannot visit device port with IP/MAC
•
hosts in Blocked Sites.
When Type is Network Access, you can configure IP Address, IP Segment and
MAC Address.
You can select IP address, IP segment and MAC address.
Enter IP Address, Start Port and End Port that is allowed or forbidden.
When Type is IP Address, they can be configured. Start Port and End Port can
be configured only in Network Access Type.
Certificate.
111