Register; Figure 71 Register Interface; Table 39 Register Parameters - Honeywell Performance Series User Manual

Parameter
Protocol Type
Host IP
Port
Auto Report Plan
3. Click Apply to complete the settings.

Register

You can register the Device into the specified proxy server which acts as
the transit to make it easier for the client software to access the Device.
1. Go to Main Menu > Network > Register.

Figure 71 Register Interface

2. Configure the settings for the register parameters.

Table 39 Register Parameters

Function
Enable
Server IP Address
Port
Sub Service ID
Performance Series Embedded NVR User Guide
Description
In the Protocol Type list, select protocol type. The default is Alarm
Center.
The IP address and communication port of the PC installed with
alarm client.
In the Auto Report Plan list, select time cycle and specific time for
uploading alarm.
The Register interface is displayed.
Description
Enable the register function.
Enter the server IP address or the server domain that you want to
register to.
Enter the port of the server.
This ID is allocated by the server and used for the Device.
69