Figure 197 Parameters; Table 80 Parameters - Honeywell Performance Series User Manual

Figure 197 Parameters

4. Configure the parameters.

Table 80 Parameters

Parameter
Enable
Rule
Schedule
Alarm-out Port
Post-Alarm
Report Alarm
Send Email
Record Channel
176
Description
Click to enable or disable the face detection.
Click Setting to draw areas to filter the target.
You can configure two filtering targets (maximum size and minimum
size). When the target is smaller than the minimum size or larger than
the maximum size, no alarms will be activated. The maximum size
should be larger than the minimum size. Left click to drag the four
angles to adjust the size.
Configure the period and in the set time range, the corresponding
configuration item will be linked to start the alarm.
The alarm device (such as lights, sirens, etc.) is connected to the alarm
output port. When an alarm occurs, the NVR device transmits the
alarm information to the alarm device.
When the alarm ends, the alarm extended for a period of time. The
time range is from 0 seconds to 300 seconds.
Select the check box. When an alarm occurs, the NVR device uploads
an alarm signal to the network (including the alarm center).
•
This function is for some series products only.
•
You need to set the alarm center first. For details, see
Center.
Select the check box. When an alarm occurs, the NVR device sends an
email to the set mailbox to notify the user.
You need to set the email first. For details, see Email.
Select the check box and select the needed recording channel
(support multiple choices). When an alarm occurs, the NVR device
activates the channel for recording.
You need to enable intelligent recording and auto recording first. For
details, see Schedule.
Performance Series Embedded NVR User Guide
Alarm