Honeywell Performance Series User Manual page 68

Parameter
Flip
Exposure
Backlight Mode
WB Mode
Day/Night Mode
3. Click Apply.
44
Description
Set monitor video display direction. It includes Normal, 180°, 90°, 270°.
Auto Iris
•
It is for the camera of auto iris only.
•
After enable auto iris function, the iris can automatically zoom
in/zoom out according to the brightness of the environment and the
image brightness changes too.
• If disable the auto iris function, the iris does not automatically zoom
in/zoom out according to the brightness of the environment when
the iris is at the biggest value.
3D NR
This function specially applies to the image which frame rate is
configured as 2 at least. It reduces the noises by making use of the
information between two frames. The bigger the value is, the better the
effect.
You can set camera Backlight mode.
•
SSA: In the backlight environment, the system can automatically
adjust image brightness to clearly display the object.
•
BLC:
Default: The device auto exposures according to the environment situation
so that the darkest area of the video is cleared.
Customize: After select the specified zone, the system can expose the
specific zone so that the zone can reach the proper brightness.
•
WDR: In backlight environment, it can lower the high bright section
and enhance the brightness of the low bright section. So that you can
view these two sections clearly at the same time.
•
HLC: In the backlight environment, it can lower the brightness of the
brightest section and reduce the area of the halo and lower the
brightness of the whole video.
• Close: It is to disable the BLC function.
The WB mode affects the image whole hue so that the image can
accurately display the environment status.
Configure the color and black & white mode of the image. This setting is
not affected by the configuration files. The default setting is Auto.
•
Color: The camera outputs color image only.
• Auto: Depends on the camera, such as overall brightness and
whether there is an IR light, either color image or black & white
image is output.
•
B/W: The camera outputs Black and white image only.
•
Sensor: It is to set when there is peripheral connected IR light.
The Sensor item is for some non-IR device only.
Performance Series Embedded NVR User Guide