Table 76 Exception Parameters - Honeywell Performance Series User Manual

Table 76 Exception Parameters

Parameter
Event Type
Enable
Less than
Alarm-out Port
Post-Alarm
Show Message
Report Alarm
Send Email
Record Channel
PTZ Linkage
Tour
Snapshot
Log
164
Description
•
Disk: Sets process method when there is a HDD event such as HDD
error, no HDD, no space.
•
Network: Sets process method when there is a network event such as
disconnection, IP conflict, MAC conflict.
•
Device: Sets process method when there is a device event such as fan
speed exception.
Different series products support different event types. The actual product
shall prevail.
Check the box to enable the function.
System generates an alarm once the HDD space is less than the threshold.
For HDD No Space type only.
The alarm device (such as lights, sirens, etc.) is connected to the alarm
output port. When an alarm occurs, the NVR device transmits the alarm
information to the alarm device.
When the alarm ends, the alarm extended for a period of time. The time range
is from 0 seconds to 300 seconds.
Check box to enable a pop-up message in your local host PC.
Select the check box. When an alarm occurs, the NVR device uploads an
alarm signal to the network (including the alarm center).
•
This function is for some series products only.
•
You need to set the alarm center first. For details, see
Select the check box. When an alarm occurs, the NVR device sends an email
to the set mailbox to notify the user.
You need to set the email first. For details, see Email.
Select the check box and select the needed recording channel (support
multiple choices). When an alarm occurs, the NVR device activates the
channel for recording.
You need to enable intelligent recording and auto recording first. For details,
see Schedule.
Select the check box and click Setting to select the channel and PTZ action.
When an alarm occurs, the NVR device associates the channel to perform
the corresponding PTZ action. For example, activate the PTZ in channel one
to turn to the preset point X.
•
Tripwire alarm supports to activate PTZ preset point only.
•
You need to set the corresponding PTZ actions first, see
Select the check box and select the channel for tour. When an alarm occurs,
the local interface of the NVR device displays the selected channel screen.
•
You need to set the time interval and mode for tour first, see Tour.
•
After the tour is over, the preview interface is restored to the screen
split mode before the tour.
Select the Snapshot check box to take a snapshot of the selected channel.
To use this function, go to Main Menu > CAMERA > ENCODE > Snapshot, in
the Mode list, select Event (Trigger).
Select the check box, the NVR device records the alarm information in the
log when an alarm occurs.
Performance Series Embedded NVR User Guide
Alarm Center.
PTZ Control.