Figure 69 Alarm In; Table 19 Alarm-In Port Parameters - Honeywell 35 Series User Manual

The Alarm In interface is displayed.

Figure 69 Alarm In

2. Set Alarm-in Port channel number and then select the enable check
box to enable the function.
3. Configure parameters.

Table 19 Alarm-in Port Parameters

Parameter
Alarm in
Enable alarm in
Normal state
Port name
Event Actions
Schedule
4. Click APPLY.
Camera Alarm In
After connecting the alarm device to the channel camera alarm input port,
system can trigger the corresponding alarm operations when there is
alarm signal from the alarm input port of camera.
1. Go to Main Menu > Event > Alarm In > Camera Alarm In.
The Camera Alarm In interface is displayed.
Honeywell 35 Series Network Video Recorder User Guide
Description
Select a port to set alarm, the alarm device is also connected to the
correspond port.
Check the box to enable the function.
N/O (normal open) or N/C (normal close).
Input the port name, the name will show on the alarm information
message.
Refer to Table 17
Define a period during which the alarm is active. For details, see
Detection.
Motion
57