Table of Contents
Advertisement
2. Specifications and Model Selection Guide
2.1 Specifications
Cell Constants
0.01, 0.1,1.0, 5, 10, 20, 25 and 50 cm
Electrode Material
Nickel or Platinum, as specified.
Wetted Parts
Cell Body:
Electrodes:
Mounting Materials:
Internal Sealing Materials: Viton, Teflon & EPDM
Pressure and Temperature (See Fig. 1-1)
125 psig (862 kPa) max. @ 23 F (-5 C)
90 psig (621 kPa) max. @ 122 F (50 C)
50 psig (345 kPa) max. @ 176 F (80 C)
Maximum Pressure
During Insertion or Removal: 50 psig.
Mounting
1-1/2" NPT male pipe. Overall length of removal device: approximately 20 or 22 inches (allow additional
clearance for cell withdrawal). See Figs. 3-1 and 3-2.
Purge Port
1/4" NPT female opening.
Insertion Depth
Varies between 4.5" and 6.8" nominal, depending upon cell constant. Greater insertion depths are optional.
See Figs. 3-1 and 3-2.
Electrical Connections
Three leads with integral automatic temp. compensator. Two leads without integral automatic temp.
compensator. Four leads with integral automatic temp. compensator)Table III = 333).
7/99
4909 CPVC Conductivity Cell Insertion/Removal Assembly– Operations Manual
-1
.
Polyethersulfone (PES).
See above.
Chlorinated Polyvinyl Chloride (CPVC).
Specifications and Model Selection Guide
7
Advertisement
Table of Contents
