Shift Cable Adjustment - Polaris RZR 900 2017 Service Manual

SHIFT CABLE ADJUSTMENT

1. Locate the shift cable attached to the transmission
case in the right rear wheel well area.
q
2. Inspect shift cable , clevis pin, pivot bushings, and
w
dust boot . Replace if worn or damaged.
3. If adjustment is required, loosen the lower jam nut
and pull the cable out of the mount
t
upper jam nut .
4. Adjust the shift cable so there is the same amount of
cable travel when shifting slightly past HIGH gear and
PARK.
5. Thread the upper or lower jam nut as required to
obtain proper cable adjustment.
NOTICE
This procedure may require a few attempts to obtain
the proper adjustment.
6. Once the proper adjustment is obtained, place the
shift cable and upper jam nut into the mount. Tighten
the lower jam nut against the mount.
9930588 R02 - 2017-2020 RZR 900 900/S 900/S4 1000/S 1000/S4 Service Manual
© Copyright Polaris Industries Inc.
7. Start engine and shift through all gears to ensure the
shift cable is properly adjusted. If transmission still
ratchets after cable adjustment, the transmission will
require service.
r
e
to move the
TRANSMISSION
7
7.5