Button To Tower Clearance Inspection; Bearing Inspection; Clutch Inspection - Polaris RANGER 500 2017 Service Manual

Hide thumbs Also See for RANGER 500 2017:

Table of Contents

2. Rubber backed buttons can be used in all RANGER

clutches if the hollow roller pin is changed to the solid

The rubber side of the button is positioned toward the

solid roller pin.

BUTTON TO TOWER CLEARANCE

1. Inspect for any clearance between spider button to

tower. If clearance exists, replace all buttons and

inspect surface of towers. See "Spider Removal"

Button to Tower Clearance:

2. Inspect sheave surfaces. Replace the entire clutch if

worn, damaged or cracked.

9850043 R01 - 2017-2021 RANGER 500 / 570 Service Manual

1. Rotate the clutch bearing in both clockwise and

counter-clockwise directions.

• The non-braking bearing should rotate both directions

on the shaft with only a slight amount of drag.

2. Verify there is no binding or rough spots. If problems

are noted continue with disassembly.

Remove cover, spring, and spider following instructions

for drive clutch removal, then proceed as follows:

1. Remove the moveable sheave spacer sleeve

Inspect for damage and wear.

Chapters

Table of Contents