Access RAD ASMi-54 Installation And Operation Manual page 63

Installation and Operation Manual
Parameter Possible Values
Transmission Annex A/F
Mode
Annex B/G
PME
Configuration
Configuring the Clock Source
Transmitted data can be clocked either from an internal clock within the ASMi-54,
or from an external clock via the SHDSL links.
To configure the clock source:
1. Select Main Menu>Configuration>Physical Layer>SHDSL.
2. Select Clock Source and toggle between Internal and RX Clock.
3. Press <S> to save the changes.
Configuring the SHDSL PME Ports
To configure the SHDSL PME ports:
1. Select Main Menu>Configuration>Physical Layer>SHDSL.
2. Select PME Configuration.
3. Press <F> to change the number of the PME (Physical Medium Entity).
4. Press <S> to save the changes.
ASMi-54 Ver. 1.0
Remarks
The regional setting of the SHDSL span.
Default: Annex B/G
Note: This parameter can be configured in STU-C mode only.
The configuration of the PME (Physical Medium Entity),
Configuring the SHDSL PME Ports
see
The SHDSL PCS Port Configuration screen appears (see
Internal: STU-C – To set the internal clock as the clock source.
RX Clock: STU-R – To set an external clock (from SHDSL link) to clock the
clock source.
The SHDSL PCS Port Configuration screen appears (see
The SHDSL PME Port Configuration screen appears (see
parameters are described in
.
Table 4-4
.
Configuring for Operation
Chapter 4 Configuration
Figure 4-16
).
Figure 4-16
).
Figure 4-17 ). The
4-13