Defining The Bridge; Defining Vlans; Defining Bridge Ports - Access RAD ASMi-54 Installation And Operation Manual

Chapter 5 Configuring Typical Applications

Defining the Bridge

Defines the Bridge entity.
To define the bridge:
1. Open the Bridge menu (Main>Configuration>Application>Bridge).
2. Define the bridge parameters. See

Defining VLANs

Define the required VLAN and add to it the relevant bridge ports.
To define a VLAN:
1. In the Bridge menu, select VLAN members to open the VLAN membership
2. Leave the parameters at their default settings (VLAN-Unaware).
3. Add the relevant ports to the defined VLAN (including the Host bridge port if

Defining Bridge Ports

The unit is supplied with the Bridge Ports preconfigured for basic use and do not
need to be reconfigured. The factory set configuration is shown in
reconfigure the ports, the configuration for each port must first be deleted. See
Chapter 4, Configuring the Bridge Ports
5-4 Configuring the Bridge
information on each of the parameters.
configuration menu.
To define and create a new VLAN, see
more information.
it is the VLAN used for management).
Table 5-1. Factory Set Bridge Port Settings
Bridge Port Configured to
1 Reserved for management host; appears after
providing the host with the IP address.
2 Fast Ethernet Port 1
3 Fast Ethernet Port 2
4 Fast Ethernet Port 3
5 Fast Ethernet Port 4
6 PCS Port 1
Installation and Operation Manual
Configuring the Internal Bridge
Configuring the Internal Bridge
for more details.
for more
for
Table 5-1
. To
ASMi-54 Ver. 1.0