Troubleshooting - Access RAD ASMi-54 Installation And Operation Manual

Chapter 6 Diagnostics and Troubleshooting
6.4
Use the chart shown in
operation.
Fault
Power led off
Ethernet Link Led off
No traffic flow between two
units
Partial Traffic Flow
6-22

Troubleshooting

Troubleshooting
Table 6-16
Table 6-16. Troubleshooting Chart
Probable Cause
No power supplied to unit
•
No Ethernet Link detected
•
Ethernet port in switch and
ASMi-54 are not in the same
rate or duplex mode
Configuration or logical layer
problems
Timing configuration is not
properly set
Installation and Operation Manual
to identify and remedy problems in unit
Remedial Action
•
Check power source.
•
Check power cable connected and
correctly wired.
•
Check cable connected and
correctly wired.
•
Check switch and ASMi-54 Ethernet
port configuration (negotiation,
rate, duplex mode).
•
Use Event Log File to check events.
•
Use System Interface Status screen
for assistance. All active ports that
show Activation–Up, should show
Operation–Up.
•
Use Event Log File to check events.
•
Check ASMi-54 configuration and, if
necessary, other ASMi-54
parameters.
•
Check timing settings.
ASMi-54 Ver. 1.0