Access RAD ASMi-54 Installation And Operation Manual page 115

Installation and Operation Manual
Downloading Application Files via XMODEM
Downloading application files using the XMODEM protocol is performed from the
Boot Manager menu.
To download application file via XMODEM:
1. Configure your ASCII terminal or terminal emulation utility running on your PC
2. Access the Boot Manager menu.
3. From the Boot Manager menu, select Download Files or an Application by
4. Select the backup partition by typing its number, 0 or 1.
5. Send the software release file to ASMi-54 using the XMODEM utility of you
Downloading Application Files via TFTP
To download application file via TFTP:
1. From the Boot Manager menu, select System Configuration.
2. Configure the IP parameters of ASMi-54 (IP address, IP mask and default
3. Start a TFTP application.
4. Configure the TFTP communication parameters as follows:
5. Select a local software release file to download.
6. Enter the TFTP server IP address.
7. Start downloading.
ASMi-54 Ver. 1.0
to the 115.2 kbps data rate.
The Boot Manager menu appears (see
XMODEM.
ASMi-54 displays the following message:
Select Copy number for download (0)
ASMi-54 responds with the following string:
Please start the XMODEM download.
terminal application.
Once the downloading is completed, ASMi-54 saves the new release as an
active partition, the former active partition turns into backup, and the boot
sequence continues normally.
If a failure occurs during the download, the partially downloaded software is
erased. In this case, only active software is left in the flash memory.
gateway). These parameters are valid only for the TFTP file transfer via the
Boot Manager.
Connection timeout – more than 30 seconds to prevent an automatic
disconnection during the backup partition deletion (about 25 seconds).
Block size – 512 bytes.
UDP port – 69.
Appendix B Boot Sequence and Downloading Software
Figure B-1
Transferring the Software and Configuration Files
).
B-3