Configuring Ip Host Parameters - Access RAD ASMi-54 Installation And Operation Manual

Installation and Operation Manual
Main Menu > Configuration > System > Management > Device Information
Description
1. Name
2. Location
3. Contact
S - Save
ESC-Previous menu; !-Main menu; &-Exit

Configuring IP Host Parameters

You can manage the unit via a network management station connected to one of
the unit's ports. To establish a proper connection, it is necessary to configure the
Host IP parameters. In addition, by selecting a forwarding mode and VLAN
parameters, it is possible to create a separate management VLAN.
To define the Host IP parameters:
1. Select Main Menu>Configuration>System>Management.
2. Select Host IP.
3. In the Host IP screen:
4. From the Encapsulation screen, select Host Tagging and toggle between
ASMi-54 Ver. 1.0
... (ASMi-54, HW Version 0.00, SW Version 1.00)
... (ASMi-54)
... (Location of the device)
... (Name of the contact person)
Figure 4-4. Typical Device Information Screen
The Management screen appears (see
The Host IP screen appears (see
1. Select IP Address and enter the IP address of the IP host.
2. Select IP Mask and enter the host IP subnet mask.
3. Select Default Gateway and enter the default gateway IP address.
4. Select Read Community and type the name of a community with
read-only authorization.
The default is Public.
5. Select Write Community and type the name of a community with write
authorization.
6. Select Trap Community and type the name of a community to which the
unit should send traps.
7. Select Encapsulation to define VLAN tagging performed by the host.
The Encapsulation screen appears (see
Untagged and Tagged.
Untagged – The host sends and receives frames with no VLAN tag
to/from the bridge.
ASMi-54
Figure 4-3
Figure 4-5
Figure 4-6
Configuring for Management
Chapter 4 Configuration
).
).
).
4-3