Access RAD ASMi-54 Installation And Operation Manual page 64

Chapter 4 Configuration
Main Menu > Configuration > Physical Layer > SHDSL > PME
Configuration
PME (Physical Medium Entity)
1. Administrative Status
2. Line Probe
3. Line Rate
4. Current Margin
5. Worst Margin
6. Loop Attenuation Threshold (dB)[0...127] (0)
7. SNR Margin Threshold (dB)[0...15]
>
F-Forward
ESC-Previous menu; !-Main menu; &-Exit
Parameter Possible Values
PME (Physical 1 – 4
Medium Entity)
Up
Administrative
Status Down
Line Probe Disable
Enable
Line Rate 192000-
5696000 bps
Current Margin -10...0...21
Worst Margin -10...0...21
Loop 0...127
Attenuation
Threshold (dB)
4-14 Configuring for Operation
Figure 4-17. SHDSL PME Port Configuration Screen
Table 4-4. SHDSL PME Port Configuration Parameters
Remarks
Index of the SHDSL PME.
Default: 1
Administrative status of the SHDSL PME.
Default: Up
Enable/disable support for Line Probe of the units in an SHDSL span.
Default: Disable
The transmission rate for the associated SHDSL PME in bits-per-
second (bps) and includes both payload (user data) and any
applicable framing overhead.
Default: 192000
The downstream/upstream current condition target SNR margin in
dB. To configure the current margin, see
Current Margin
Default: 0 (Disable)
Note: Appears only when Line Probe is "Enable".
The downstream/upstream worst case target SNR margin in dB. To
configure the worst margin, see
Margin
.
Default: 0 (Disable)
Note: Appears only when Line Probe is "Enable".
The loop attenuation alarm threshold.
Default: 0
Installation and Operation Manual
ASMi-54
> (0)
> (0)
.
Configuring the SHDSL PME Worst
(1)
(Up)
(Disable)
(192000)
(0)
Configuring the SHDSL PME
ASMi-54 Ver. 1.0