Testing The Unit; Running A Ping Test - Access RAD ASMi-54 Installation And Operation Manual

Installation and Operation Manual
6.5
ASMi-54 checks network integrity by running ping, trace route, or loopback tests.

Running a Ping Test

You can ping the remote IP host to check the IP connectivity.
To ping an IP host:
1. Select Main Menu>Diagnostics.
2. Select Ping.
3. Configure the following:
4. Select Send Ping to start sending pings.
5. Select Stop Ping to stop the ping test.
Main Menu > Diagnostics
1. Ping
2. Trace Route
ESC-Previous menu; !-Main menu; &-Exit; ?-Help
Main Menu > Diagnostics > Ping
1.
2.
3.
4.
ESC-Previous menu; !-Main menu; &-Exit; ?-Help
ASMi-54 Ver. 1.0

Testing the Unit

The Diagnostics menu appears (see
The Ping menu appears (see
1. Destination IP Address: IP address of the host that you intend to ping,
0.0.0.0 to 255.255.255.255.
2. Number of Frames to Send: Select 0 to send a continuous stream of
frames, or 1-50 to send a specified number of frames.
3. Frame Length: Length of the frame (64-1500).
The results are shown in the lower scrolling message window.
Figure 6-24. Diagnostics Menu
Destination IP Address
Number of Frames to Send [0 – 50]
Send Ping
Stop Ping
Chapter 6 Diagnostics and Troubleshooting
Figure 6-24
Figure 6-25
).
ASMi-54
>
>
ASMi-54
Figure 6-25. Ping Menu
).
0.0.0.0)
(0)
(Yes)
()
Testing the Unit 6-23