Access RAD ASMi-54 Installation And Operation Manual page 69

Installation and Operation Manual
MAC table handling
1. MAC address
2. VLAN ID [1-4094]
3. Bridge port [1 – N]
S - Save
ESC-Previous menu; !-Main menu; &-Exit; ?-Help
To remove a static address from the table:
1. Select Main Menu>Configuration>Applications> Bridge>Static MAC Table.
2. Select a MAC address that you want to remove and press <R>.
To clear the MAC table:
1. Select Main Menu>Configuration>Applications>Bridge>Static MAC Table.
2. Press <C> to clear the table.
3. Press <Y> to confirm deletion of all MAC addresses from the table.
Configuring the Bridge Ports
The unit is supplied with the Bridge Ports preconfigured for basic use. The
factory-set configuration is shown in
Note
To reconfigure the ports, first delete the configuration for each port.
Bridge Port
1
2
3
4
5
6
ASMi-54 Ver. 1.0
Figure 4-22. Static MAC Table, Add Mode
The Static MAC Table screen appears (see
The MAC address is deleted from the table.
The Static MAC Table screen appears (see
The following message appears:
Table 4-6. Factory Set Bridge Port Settings
Configured to
Reserved for management host
Fast Ethernet Port 1
Fast Ethernet Port 2
Fast Ethernet Port 3
Fast Ethernet Port 4
PCS Port 1
ASMi-54
... (00-00-00-00-00-00)
(1)
(1)
Figure 4-21
Figure 4-21
Are you sure (Y/N)?
Table 4-6
.
Configuring for Operation
Chapter 4 Configuration
).
).
4-19