Access RAD ASMi-54 Installation And Operation Manual page 27

Installation and Operation Manual
0
0 1 2 3
VERSION
TIME TO LIVE
Bit 0
DS5
DSCP: six bits (DS5–DS0)
Management
ASMi-54 performance can be monitored locally from an ASCII terminal, or from a
remote site using Telnet or the ConfiguRAD Web-based application. RADview-Lite
is also supported.
Inband Management
ASMi-54 supports inband management via Telnet, SNMP, and Web (ConfiguRAD).
Configuration, monitoring, and statistics are available.
Out-of-band Management
ASMi-54 enables full configuration and diagnostics via an ASCII terminal. The ASCII
terminal is connected to the control port on the rear panel.
For a description of ASCII terminal activation, including general instructions for
navigating through the system menus and windows, and modifying data, see
Chapter 3
Management Access
The unit's architecture allows access from every bridge port to both the host and
remote site devices. In certain configuration modes, a total separation of
management traffic from user traffic can be achieved.
VLAN-Based Management Scheme
In this scenario, traffic coming from the remote CPE uses two VLANs: one for user
traffic, for which the CPE may use tag stacking, and the other for management
traffic. All CPEs connected to the ASMi-54 share the same management VLAN.
In VLAN-Aware mode, ASMi-54 forwards the management traffic to the
management station in the Ethernet network. Because a different VLAN is used,
total separation between user traffic and management traffic is maintained.
ASMi-54 Ver. 1.0
1
4 5 6 7 8 9 0 1
IHL
TOS
IDENTIFICATION
PROTOCOL
DESTINATION ADDRESS
OPTIONS
Bit 1 Bit 2
DS4 DS3
Figure
.
2 3 4 5 6 7 8 9
FLAGS
SOURCE ADDRESS
Figure 1-3. IP Header
Bit 3 Bit 4
DS2 DS1
1-4. ToS Byte DSCP Field
Chapter 1 Introduction
2
0 1 2 3 4 5 6 7
TOTAL LENGTH
FRAGMENT OFFSET
HEADER CHECKSUM
PADDING
Bit 5 Bit 6
DS0 XX
Functional Description
3
8 9 0 1
Bit 7
XX
1-11