Access RAD ASMi-54 Installation And Operation Manual page 61

Installation and Operation Manual
Main Menu > Configuration > Physical Layer > Ethernet
1. Administrative Status
2. Auto Negotiation
3. Flow Control
4. Max Capability Advertised
5. MDIX Auto Cross Over
F-Forwards; B-Backwards; S-Save
ESC-Previous menu; !-Main menu; &-Exit
Parameter Possible Values
Port 1 or 4
Administrative Up
Status
Down
Auto Negotiation Enable
Disable
Flow Control Enable
Disable
Max Capability 10baseT Half Duplex
Advertised
10baseT Full Duplex
100baseTX Half Duplex
100base TX Full Duplex
Speed & Duplex 10baseT Half Duplex
10baseT Full Duplex
100baseTX Half Duplex
100base TX Full Duplex
MDIX Auto Cross Enable
Over
Disable
ASMi-54 Ver. 1.0
Port
Figure 4-15. Fast Ethernet Port Configuration Screen
Table 4-2. Fast Ethernet Port Configuration Parameters
Remarks
The Fast Ethernet port number.
Default: 1
The Fast Ethernet activation.
Default: Up
Enables autonegotiation signaling over the Ethernet.
Default: Enable
Used to configure the default administrative PAUSE mode for
this interface.
Default: Disable
Specifies the set of capabilities advertised by the local
autonegotiation entity.
Default: 100BaseTX full-duplex
Note: Appears only when autonegotiation is enabled.
The static speed and duplex that the port will use.
Default: 100BaseTX full-duplex
Note: Appears only when autonegotiation is disabled.
Enables and disables Auto Cross Over functionality.
Default: Enable
ASMi-54
(1)
(Up)
(Enable)
(Disable)
(100base – TX Full Duplex)
(Enable)
Configuring for Operation
Chapter 4 Configuration
4-11