Chapter 4 Configuration
Configuring the Fast Ethernet Port
The following parameters can be configured for the Ethernet ports at the physical
level:
•
•
•
•
•
•
To configure the Fast Ethernet port:
1. Select Main Menu>Configuration.
2. Select Physical Layer.
3. Select Fast Ethernet.
4. Press <S> to save the changes.
Main Menu > Configuration > Physical Layer
1. Ethernet
2. SHDSL
>
ESC-Previous menu; !-Main menu; &-Exit
4-10
Configuring for Operation
Administrative Status
Autonegotiation
Flow Control
Maximum advertised capability for autonegotiation procedure
Data rate and duplex mode (only when autonegotiation is disabled)
MDIX Auto Cross Over.
The Configuration screen appears (see
The Physical Layer screen appears (see
The Fast Ethernet Port Configuration screen appears (see
The parameters are described in
Figure 4-14. Physical Layer Screen
Figure 4-1
Figure 4-14
Table 4-2
ASMi-54
>
>
Installation and Operation Manual
).
).
Figure 4-15
.
ASMi-54 Ver. 1.0
).