Access RAD ASMi-54 Installation And Operation Manual page 71

Installation and Operation Manual
Parameter Possible Values
Bridge Port 1 - 6
Number
Bind
Activation Enable
Disable
Ingress Filtering Enable
Disable
Accept Frame All
Type
Tag Only
Port VID / 1–4094
Stacking VID
Copy Original Enable
Priority
Disable
Default Priority 0-7
Tag
Egress Tag Stacking
Handling
Stripping
None
Ingress Tag Stacking
Handling
Stripping
None
ASMi-54 Ver. 1.0
Table 4-7. Bridge Port Parameters
Remarks
Bridge port number.
Default: 2
Note: Bridge port number 1 is reserved for the host bridge port.
The type of port to be bound. To configure a bridge port, see
Configuring a Bridge Port
Specifies if this port is part of the bridge or not. Press the option
number to toggle enable/disable.
Default: Enable
When Enabled, the device discards incoming frames for VLANs which
do not include this Port in its Member set. When Disabled, the port
accepts all incoming frames.
Default: Disable
Note: Appears only when in VLAN-Aware mode.
Tag Only specifies that the device discards untagged frames. All
specifies that untagged frames received on this port are accepted
and assigned to the PVID for this port.
Default: All
Note: Appears only when in VLAN-Aware mode.
This is the PVID, the VLAN ID assigned to untagged frames or
priority-tagged frames received on this port. If Stacking is enabled,
this is the tag to be added.
Default: 2
Copy priority from original frame.
Default: Disable
Default VLAN frame priority. Applies to untagged frames.
Default: 0
Stacking: Adds the PVID to every frame transmitted from the port.
Stripping: Removes the first VLAN tag from every transmitted frame,
on the egress of the port.
Default: None
Stacking: Adds the PVID to every frame received on the ingress of
the port.
Stripping: Removes the first VLAN tag from every received frame, on
the ingress of the port.
Default: None
Chapter 4 Configuration
.
Configuring for Operation 4-21