Defining The Host; Defining The Default Gateway; Defining Managers - Access RAD ASMi-54 Installation And Operation Manual

Chapter 5 Configuring Typical Applications

Defining the Host

Defines the host parameters such as IP address and subnet mask, and the
read/write communities.
To define the host:
1. From the Management menu (Main>Configuration>System>Management),
2. From the Host IP menu, configure the following:
3. Press <ESC> to return to the Management menu.
4. Press <S> to save the changes.

Defining the Default Gateway

To define the default gateway:
1. From the Management menu (Main>Configuration>System>Management),
2. In the Host IP menu, select Default Gateway.
3. Enter 172.17.143.1, or specify an IP address of 0.0.0.0 to disable the default

Defining Managers

In this step you define the managers and specify which manager(s) will receive
SNMP traps.
Up to ten managers can be defined. Entering the IP address and corresponding
subnet mask defines each management station. In addition, you can temporarily
prevent a manager station from receiving traps, by masking the network
manager.
To define new managers:
1. From the Management menu (Main>Configuration>System>Management),
2. Enter A (Add) to add a new network manager.
3. Specify an IP address for the new manager.
5-2 Configuring the Management Parameters
select Host IP.
The Host IP menu appears.
ASMi-54 IP address – 172.17.143.140
Host IP mask – 255.255.255.0
Host default gateway IP address – 172.17.143.1
Read Community – Public
Write Community – Private
Trap Community – Public.
select Host IP.
The Host IP menu appears.
gateway.
select Manager List to open the Manager List menu.
Installation and Operation Manual
ASMi-54 Ver. 1.0