Access RAD ASMi-54 Installation And Operation Manual page 14

Quick Start Guide
Starting a Terminal Session
To start a terminal session:
1. Turn on the control terminal PC and set its default port parameters to 9,600
2. Set the terminal emulator to ANSI VT100 emulation (for optimal view of
3. Set the terminal screen to show 132 characters.
4. Enter your user name and password and proceed with the management
Note The default user name is su, and the default password is 1234.
Configuring ASMi-54 SHDSL Ports
When working with two devices back to back, one device should be configured as
CO (Central Office) and the other device as CPE (Customer Premise Equipment).
The factory default setting is CPE, so only one device needs to be changed.
To configure ASMi-54 SHDSL ports:
•
Configuring ASMi-54 for Management
To configure ASMi-54 for management:
1. From the Host menu, select Main>Configuration>System>Management>Host,
2. From the Encapsulation menu, select
To configure the manager IP addresses:
•
2 Configuring ASMi-54
bps, 8 bits/character, 1 stop bit, no parity.
system menus).
session.
Set one device to CO (internal clock) and leave the other as CPE (receive
clock).
and configure the following parameters:
Host IP address
Host IP mask
Default gateway.
Main>Configuration>System>Management>Host>Encapsulation, and
configure Host tagging (untagged/tagged). Note that selecting the tagged
option displays the following additional parameters that need to be defined:
Host VLAN ID
Host VLAN Priority
From the Manager List menu, select
Main>Configuration>System>Management>Managers List, and enter the
manager IP address(es).
Installation and Operation Manual
ASMi-54 Ver. 1.0