Access RAD ASMi-54 Installation And Operation Manual page 42

Chapter 3 Operation
Menu
QoS
Priority Mapping
3.4
Configuration and monitoring operations are performed locally from an ASCII
terminal connected to the control port or from a Web browser, via ConfiguRAD or
RADview-Lite, or via SNMP.
Working with the Terminal
ASMi-54 includes a V.24/RS-232 asynchronous DCE port designated CONTROL,
which is terminated in a 9-pin D-type female connector. The control port
continuously monitors the incoming data stream and immediately responds to
any input string received through this port.
The control port can be configured to communicate at the following rates: 9.6,
19.2, or 115.2 kbps.
To start a terminal control session:
1. Make sure all cables and connectors are properly connected.
2. Connect the unit to a PC equipped with an ASCII terminal emulation
3. Turn on the control terminal PC and set its default port parameters to 9,600
4. Set the terminal emulator to ANSI emulation (for optimal view of system
5. Set the terminal emulator to view a 132-character screen width.
6. When the initialization and self-test are over, a menu appears displaying
3-6 Configuration and Management Alternatives
Table 3-8. Default QoS Settings
Parameter
Priority Classification
User Priority 0
User Priority 1
User Priority 2
User Priority 3
User Priority 4
User Priority 5
User Priority 6
User Priority 7
Configuration and Management Alternatives
application (for example, Windows Hyper Terminal or Procomm).
baud, eight bits/character, one stop bit, no parity.
menus).
initialization and self-test results.
Installation and Operation Manual
Default Value
802.1p
Traffic Class 0
Traffic Class 0
Traffic Class 0
Traffic Class 0
Traffic Class 0
Traffic Class 0
Traffic Class 0
Traffic Class 0
ASMi-54 Ver. 1.0