Access RAD ASMi-54 Installation And Operation Manual page 13

Quick Start Guide
The ASMi-54 should be installed by an experienced technician only. If you are
familiar with the ASMi-54, use this guide to prepare the unit for operation.
1.
Connecting the Interfaces
To connect the interfaces:
1. Connect the user LAN to the RJ-45 connector designated 10/100BaseT (up to
2. Connect the control terminal to the front panel CONTROL connector.
Connecting the Power
To connect the power:
•
2.
Configure ASMi-54 to the desired operation mode via an ASCII terminal connected
to the rear panel CONTROL port. After configuring, you can manage the unit over
Telnet, a PC running a Web browsing application (ConfiguRAD) or SNMP via the
Ethernet port or inband.
Note Remote management requires the configuration of an IP address (see
ASMi-54 Ver. 1.0
Installing ASMi-54
four connectors).
or
Connect a Telnet host, a PC running a Web browsing application
(ConfiguRAD), or an SNMP management station to the Ethernet port.
Connect the power cable to the power socket on the ASMi-54 rear panel and
the other end to the power outlet.
The unit has no power switch. Operation starts when the power is applied to
the power connector.
Configuring ASMi-54
Chapter 4
Configuring ASMi-54
).
1