Default Jumper Settings - Xilinx KC705 User Manual

Appendix A: Default Switch and Jumper Settings
The default mode setting M[2:0] = 010 selects Master BPI configuration at board
power-on.
Table A-2: SW13 Default Switch Settings

Default Jumper Settings

See
Table A-3: Default Jumper Settings
72
Position Function
1 FLASH_A25
2 FLASH_A24
3 FPGA_M2
4 FPGA_M1
5 FPGA_M0
Figure 1-2, page 8 for locations of jumpers listed in
Default Jumper
Jumper
J32 Pin 5 to pin 6
J28 Pin 2 to pin 3
J29 Pin 1 to pin 2
J30 Pin 1 to pin 2
J5 None
J3 Pin 1 to pin 2
J43 Pin 1 to pin 2
J42 None
J47 Pin 1 to pin 2
J48 Pin 2 to pin 3
J53 None
J56 None
J68 Pin 1 to pin 2
J69 Pin 1 to pin 2
www.xilinx.com
Default
A25 Off
A24 Off
M0 Off
M1 On
M3 Off
Position
Table A-3.
KC705 Evaluation Board
UG810 (v1.3) May 10, 2013