Finisher Failure #H2-5005. Turn Off Then On, After Checking Finisher; Finisher Failure #H2-5006. Turn Off Then On, After Checking Finisher - Samsung MultiXpress M5370 Series Service Manual

4. Troubleshooting
► Error Code
H2-5005
H2-5006
H2-5098
► Error message

Finisher Failure #H2-5005. Turn off then on, after checking finisher

Finisher Failure #H2-5006. Turn off then on, after checking finisher

Finisher Failure #H2-5098. Turn off then on, after checking finisher
► Symptom
Rear Jogger operation is abnormal.
► Troubleshooting method
1) Is the Rear Jogger Home sensor (S5) working?
a) Check if the Rear Jogger home sensor actuator(SJ10 3318) is abnormality.
b) Check if the connector(JR10 8320) of Rear Jogger home sensor(S5) is disconnected.
c) Check if the connector(JR10 8320) J7 on the finisher main board(JC81–07242A) is disconnected.
d) Check discontinuity and damage of the harness(JR10 8320), replace it if required.
e) Replace the Rear Jogger home sensor(S5).
f) Replace the Finisher main board(JC81–07242A).
2) Is the Rear Jogger motor (M4) working?
a) Check if the connector(JR10 8320) of Rear Jogger motor is disconnected.
b) Check if the connector(JR10 8320) J5 on the finisher main board(JC81–07242A) is disconnected.
c) Check if there is continuity in the harness, and if not replace the harness (JR10 8320), replace as is necessary.
d) Replace the Rear Jogger motor(M4).
e) Replace the Finisher main board(JC81–07242A).
3) Is there any belt(gear) jumping noise?
a) Check if the Rear Jogger driving belt(JC81-03509A) is assembled correctly.
b) Check if the Rear Jogger driving belt(JC81-03509A) is broken. Replace the belt if it does.
c) Check if the Rear Jogger motor bracket(SJ10 3206) is fasten on tamper base(JR10 3306) by screw.
4-128 Copyright© 1995-2016 SAMSUNG. All rights reserved.