How To Use Autoscale - Owon SDS5052E-V User Manual

Figure 5-76 Wave of Freq cursor measurement

How to Use Autoscale

This is a very useful function for first time users to carry out a simple and quick test on the
input signal. The function is applied to follow-up signals automatically even if the signals
change at any time. Autoscale enables the instrument to set up trigger mode, voltage
division and time scale automatically according to the type, amplitude and frequency of
the signals.
The menu is as follows:
Function Menu Setting
Autoscale
Mode
Wave
If you want to measure the two-channel signal, you can do as the follows:
1. Press Autoscale button, the function menu will appear.
2. Press H1 to choose ON.
3. Press H2 and choose
4. Press H3 and choose
Then the wave is displayed in the screen, shown as Figure 5-78.
5.Advanced User Guidebook
Figure 5-77 Autoscale menu
ON Turn on Autoscale.
OFF Turn off Autoscale.
Follow-up and adjust both vertical and horizontal
settings.
Follow-up and only adjust horizontal scale.
Follow-up and only adjust vertical scale.
Show Multi-period waveforms.
Only show one or two periods.
for Mode item.
for Wave item.
Instruction
77