Table of Contents
Advertisement
menu.
2. Select Add in the bottom menu.
3. In the left Type menu, select Period.
4. In the right menu, select Source as CH1.
5. In the right menu, select Add. The period type is added.
6. In the left Type menu, select Frequency.
7. In the right menu, select Source as CH1.
8. In the right menu, select Add. The frequency type is added.
The measured value will be displayed at the bottom left of the screen automatically.
How to Use Autoscale
This is a very useful function for first time users to carry out a simple and quick test on the
input signal. The function is applied to follow-up signals automatically even if the signals
change at any time. Autoscale enables the instrument to set up trigger mode, voltage
division and time scale automatically according to the type, amplitude and frequency of
the signals.
E.g. If you want to measure the signal, you can do as the follows:
1. Click the
icon, click Autoscale to turn on. The function menu will appear.
2. In the bottom menu, Select Mode. In the right menu, select
3. In the bottom menu, Select Wave. In the right menu, select
4. Communication with PC
The oscilloscope supports communications with a PC through USB, LAN port or Wi-Fi.
You can use the Oscilloscope communication software to store, analyze, display the data
and remote control.
To learn about how to operate the software, you can push F1 in the software to open the
help document.
Here is how to connect with PC. First, install the Oscilloscope communication software on
the supplied CD. Then there are several ways of connection to choose from.
Using USB Port
(1) Connection: Use a USB data cable to connect the USB Device port in the right panel
of the oscilloscope to the USB port of a PC.
(2) Install the driver: Run the Oscilloscope communication software on PC, push F1 to
open the help document. Follow the steps of title "I. Device connection" in the
document to install the driver.
4.Communication with PC
20
.
.
Advertisement
Table of Contents
