How To Use Autoscale - Owon tds series User Manual

Figure 5-13 Wave of Freq cursor measurement

How to Use Autoscale

This is a very useful function for first time users to carry out a simple and quick test
on the input signal. The function is applied to follow-up signals automatically even if
the signals change at any time. Autoscale enables the instrument to set up trigger
mode, voltage division and time scale automatically according to the type, amplitude
and frequency of the signals. Press the Autoscale button to display the function menu
in the bottom.
The menu is as follows:
Function Menu Setting
AutoScale
Mode
Wave Period
If you want to measure the signal, you can do as the follows:
1. Press the Autoscale button, the function menu will appear in the bottom.
2. Select AutoScale as ON
3. Select Mode in the bottom menu, select
5.Advanced User Guidebook
ON Turn on
Autoscale.
OFF Turn off
Autoscale.
Follow-up and adjust both vertical and horizontal
settings.
Follow-up and only adjust horizontal scale.
Follow-up and only adjust vertical scale.
Show Multi-period waveforms.
Only show one or two periods.
.
56
Instruction
in the right menu.