Western Digital Ultrastar Data60 User Manual page 76

User Guide
b. Pull the PSU straight out with even pressure.
Step 6 : Remove the new PSU from its packaging.
Step 7 : Install the PSU.
a. Align the PSU in the orientation shown in the following image.
b. Slide the PSU into the slot until it seats fully into the chassis.
c. Plug the power cable into the receptacle at the back of the PSU.
d. Loop the retention clip on the PSU cables around the cable and pinch it until the clip
catches and locks in place.
Figure 47: Uninstalling PSU
Figure 48: Installing the PSU
4. Part Replacement
4.3 PSU Replacement
66