Western Digital Ultrastar Data60 User Manual page 149

User Guide
c. Team-lift the enclosure until the inner rails (which are attached to the chassis) align with
the extended mid-rails (which are attached to the rack), and guide the inner rails on the
chassis to mate with the rack rails.
d. Once the rails are mated properly, slide the enclosure into the rack until it is stopped by
the safety catch on the rails. Push the release lever on the safety latch (located on the side
of each of the rails), and push the enclosure the rest of the way into the rack.
e. As the chassis is slid into the rack, position one installer at the rear of the rack to ensure
that the pegs on the sides of the cover will slide correctly into the rear cover alignment
brackets on both sides of the rack. If the chassis does not install smoothly or snags, check
that the rear cover alignment brackets are not interfering with the chassis sidewalls, and
try again.
Figure 158: Installing the Chassis
Figure 159: Safety Latch Release
4. Part Replacement
4.9 Chassis Replacement
139